Today we are reviewing a new product from the once mastodon in the vape industry. IPV” series started its existence I don’t even remember when, but it ended with the legendary IPV” 3 Li, which, at one time, was almost every vaper. Since that time a lot of water has flowed, and the guys were releasing new IPV, but they couldn’t repeat such success. Well, I present to you the new product – V-IT kit. 

Design 

The IPV series has always stood out for its unconventional design, and this new one boasts it as well. To begin with, the shape of the flattened tube with a flattened middle, which is incredibly comfortable in the hand. The “soft touch” coating provides a very firm grip and no slipping of the box mod in your hand. The color palette does not have a single standard color scheme, they are all multicolored and look very provocative. canadian vape shop ottawa The only thing I don’t like about the design is the drip tip, which,” in my opinion,” just has to be the same color as the case. Also I don’t really like the unusual location of the Fire button as I prefer it to be on the side edge. But,” in spite of this, it is convenient to press it with both thumb and forefinger. The tank looks absolutely plain and ordinary, which is again a minus for design. It should have been made in black, in the color of the front panel, and the drip tip” colorful. Such simple solutions would completely change the design of the box mod” for the better and would not affect the price of the device significantly. 

Kit 

I will not say that the equipment is rich, as with any other maintenance-free tanks, but it has everything you need. It includes: 

V-IT mod 

V-IT tank 

2 gaskets for the connector 

2 vaporizers on Ni80 0.1 ohm” and 1 preset on 0.2 ohm” on kantal 

Spare glass 

Replacement O-rings 

USB” cable 

Operating instructions and warranty cards 

Technical Specifications 

V-IT mod 

Despite its rather large size, the “box mod” weighs only 140 grams, which makes it very light. This is mainly due to the greater use of plastic, but metal is also present. Boxmod” works from two rechargeable 18650 batteries on a chipset YiHi” SX540 “and is able to give 200 W maximum power. Boxmod” works in the following modes: Power/TC(Ni200/SS/Ti)/TCR/Bypass/Novice mode/Taste mode. The minimum supported atomizer resistance is the usual 0.05 ohm. There are also all the standard types of protection, such as short circuit, high / low resistance, overheating, wrong battery polarity and overcharging / overdischarging. The “connector” is made of steel and has a gold-plated, spring-loaded pin. Also, the box mod is not deprived of fast charging in 2A, and as always I will advise you to avoid it in order to prolong the life of the batteries. You can access the batteries by opening the lid on the bottom of the box mod.